Arduino binary logic to decimal value using Push buttons and LEDs in LabView
Our task is to Convert the binary logic into Decimal value.we have to make a LabView program that reads the binary logic from Arduino digital channel and convert it into corresponding decimal value.
Step # 1:
Open LabView and in the search bar enter Digital read n Channel.
Insert this box by right clicking on the project window and go to makerhub>Linx>peripherals>digital and pick the digital box and place it in the project window.now click on the arrow near to change digital read channel and check it into the digital read N channel.
Step # 2 :
Step # 3 :
see the figure below to understand the concept.
4x Resistors 1K
4x Push Buttons
Take 4 digital Arduino pins.connect the out put of the circuit to that pins.Give power to the circuit from Arduino board.
Final Step :
If you need the files then Comment below and Subscribe to our YouTube channel for video Tutorials.