binary to decimal in linx maker hub labview

Arduino binary logic to decimal value using push buttons and leds in LabView

Arduino binary logic to decimal value using Push buttons and LEDs in LabView

Our task is to Convert the binary logic into Decimal value.we have to make a LabView program that reads the binary logic from Arduino digital channel and convert it into corresponding decimal value.

Step # 1:

Open LabView and in the search bar enter Digital read n Channel.
Insert this box by right clicking on the project window and go to makerhub>Linx>peripherals>digital and pick the digital box and place it in the project click on the arrow near to change digital read channel and check it into the digital read N channel.

Step # 2 :

Now do all the necessary steps for creating the maker hub project.Place while loop and open and close boxes.

Step # 3 :

The easiest way is to place or modify things id to search.Go to Help > find Examples and now type in the search window Digital read n Channel.

A ready example will be open up if you have any issue placing basic parts like open and close and other peripherals.

Now Type in the search window > Bool to decimal > a bool array will be shown in the search bar pick that one and place into the connect to the digital read n channel values output line and after Boolean array connects an indicator for displaying decimal value.
see the figure below to understand the concept.

Arduino binary logic to decimal value using push buttons and leds in LabView

Step # 4 :

Hardware: Connect 4 push buttons in the configuration below. You can also connect these in the pull-down configuration.this is the pull-up configuration.
4x Resistors 1K
4x Push Buttons

Take 4 digital Arduino pins.connect the out put of the circuit to that pins.Give power to the circuit from Arduino board.

Final Step :

Open up both the windows of your project and connect Arduino to the serial port.Now select Com Port and Run the program. One more thing before running the program is to give the corresponding digital pin number to the digital array that is alongside the led array.

Now press the push buttons in a way that binary logic works that are 1-2-4-8. The corresponding number will be shown on the decimal indicator.
If you need the files then Comment below and Subscribe to our YouTube channel for video Tutorials.



About the author



Mechatronics Engineer - Solution Architect - Entrepreneur
Crazy about traveling & Writing - Being Average isn't a choice.Be happy & always have faith on yourself.

Add Comment

Click here to post a comment
Thanks for submitting your comment!